Built-in Bluetooth ® wireless technology facilitates connection with a wide range of devices.
Because there are no cables, the GT10B can be installed anywhere (Min. 10m, with no obstractions).
Can be connected by simply scanning the bar code underneath the communication unit.
Multiple units can be used simultaneously by specifying where to connect.
Accurate data transmission possible with ACK/NAK protocol built-in.
Error correction code included in the data helps prevent missing and substitution of the data.
Prevents scanning in the event of disconnection.
An orange LED will flash at 200 mm second intervals and a buzzer will sound 5 times.
Eight hours of operating time possible even with a constantBluetooth ®connection (at one scan per 5 seconds).
Battery can be charged in approx. 2.5 hrs with the exclusive unit charger (CH-GT10N).
Realizes rapid scanning of bother 2D and bar codes (twice the speed(1) of conventional units).
Improved scanning of poorly printed 2D code labels (Compared with other Denso models).
Enables pinpoint aiming and scanning, even with multiple codes in the scanning area.
Instantly scans multiple bar codes at once.
Achieves high speed scanning equal to traditional innearscanners.
Realizes single scanning of QR code combinations.
With a stronger body and the use of impact-resistant rubber, the scanner can survive a 2 m drop-the highest standard in the world.
After many years of developing high quality technology, IEC International Standards Protection Class IP54 (equivalent to JIS spash resistance) has been achieved, preventing water and dust from infiltrating the scanner.
Laser illumination of scanning area and center of scannning area Tri-color Extra Bright LED
Tri-color LED display that shows operation status
Scan completion confirmed by vibration
3 levels of buzzer volume to suit the surrounding environment
Determines if a code being scanned matches a master bar code redistered in the GT10Q.
Sorts scanned barcode data and prints out only necessary data.
Wireless connection can be disconnected by pressing and holding the magic key for a few seconds. Reconnect by switching the trigger ON.
Two types of code can be pre-registered to enable easy swithing between the two types of code by turning the magic key ON.
Turn the magic key OFF to suspend scanning, and ON to resume.
Data that is already stored (eg operations initiation code) can be sent by switching the magic key ON.
Scanned data can be retransmitted when the magic key is ON so the bar code does not need to be repeatedly scanned.
Operation of a single magic key activates or ends Bar Code Reader Mode.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|